Autoplay
Autocomplete
Previous Lesson
Complete and Continue
CCNA Level I
Tests
GNS Software for Cisco routers and Switches (2:37)
Enable Nested Virtualization (12:17)
Module 1 -
1.0.5 Packet Tracer - Logical and Physical Mode Exploration
Day 1
Chapter 2 command line intro part 1 (11:21)
Chapter 2 command line intro part 2 (4:16)
Chapter 2 Basic Device Configuration - (14:13)
Chapter 2 - Saving Configuration and Ports and IP addresses (26:09)
Day 2
OSI Model (40:52)
OSI Model Quiz
Demo - Configure Cisco Routers and Switches Basic Network (31:05)
Day 3
Chap4PhysicalLayerOctober2025 (28:24)
Chap5NumberingSystemSOct2025 (24:53)
Chapter 6 - Data Link Layer (34:46)
Day 4
Chapter 7 - Ethernet Switching (37:20)
Chapter 8 - Network Layer Part 1 (15:19)
Chapter 8 - Network Layer Part 2 - IPV4 Wireshark capture and IPv6 (24:31)
Lab 1 - Installation of GNS3 (13:04)
Lab 2 - GNS Initial Setting up A lab and connecting and labelling Routers and switches (13:40)
Lab 3 - How to set an IP subnet mask and gateway on VPCS in GNS3 (1:29)
Lab 4 - GNS3 How to configure Font Size for Consoles (1:55)
Lab 5 - Configure GNS3 Lab for two routers and two switches with RIP and test (22:12)
Day 5
Chapter 8 - Network Layer part 3 - Host Routing - Static and Dynamic Routing Protocols (32:34)
Chapter 9 - ARP (19:59)
Chapter 9 - Neighbor Discovery (7:13)
Chapter 10 - Basic Router Configuration (38:28)
Net 46 Videos
Module 10 - Basic Router Configuration (14:38)
Configure Cisco Routers and Switches Basic Network (31:05)
Module 11 - IP Addressing (29:05)
Module 11 - Broadcast Domains and Segmentation (43:52)
Module 11 - Subnetting (54:49)
Module 12 - IPV6 Addressing (17:52)
Module 12 - GUA and Link Local Addresses - SLAAC etc (18:48)
Labs
Lesson 1 - Install Windows Server 2019 - How to create a procedure using Greenshot (16:12)
Lesson 2 - Set Static IP on Windows Server 2019 (3:06)
Lesson 3 - Setup Second Network Card - Configure IPs for internal Network (5:53)
Lesson 4 - Promote domain Controller (7:01)
Lesson 5 - Setup Domain Controller two NIcs - Setup Lan Segment Windows 10 (11:48)
Lesson 6 - Install DHCP and Configure and Test (8:12)
Lesson 7 - Install Wireshark on Windows Server and Capture DHCP Traffic Analysis (18:10)
Lesson 8 - Configure DNS and Capture DNS Traffic in Wireshark (18:20)
Lesson 8 - Second Domain and Dns Transfer (15:37)
Lesson 9 - Install IIS and Configure two websites (8:54)
Lesson 10 - Install fedora 43 VM (11:00)
Lesson 11 - Install Debian 13 (13:36)
Lesson 12 - Raid Levels Demo (16:20)
Lesson 13 - Install Windows 11 (6:07)
GNS Software for Cisco routers and Switches
Lesson content locked
If you're already enrolled,
you'll need to login
.
Enroll in Course to Unlock