Autoplay
Autocomplete
Previous Lesson
Complete and Continue
CCNA Level I
Day 1
Subnetting Exam Day 9
Chapter 1 - Overview of part of chapter (32:47)
CCNA Level 1 - Introduction - CCNA packet tracer (42:13)
Chapter 2 command line intro part 1 (11:21)
Chapter 2 command line intro part 2 (4:16)
Chapter 2 Basic Device Configuration - (14:13)
Chapter 2 - Saving Configuration and Ports and IP addresses (26:09)
Day 2
OSI Model (40:52)
Chapter 3 Theory Protocols (23:54)
Demo - Configure Cisco Routers and Switches Basic Network (31:05)
Demo Setup IVP6 and IPV6 Routing (14:55)
Demo Troubleshoot IPv6 routing for above example (4:25)
Day 3
Chapter 4 - Physical Layer (43:28)
Numbering Systems (35:32)
Hexadecimal (14:24)
Demo - Setup Three routers using OSPF (33:32)
Chapter 6 - Data Link Layer (34:46)
Day 4
Chapter 7 - Ethernet Switching (37:20)
Chapter 8 - Network Layer Part 1 (15:19)
Chapter 8 - Network Layer Part 2 - IPV4 Wireshark capture and IPv6 (24:31)
Installation of GNS3 (13:04)
GNS Initial Setting up A lab and connecting and labelling Routers and switches (13:40)
How to set an IP subnet mask and gateway on VPCS in GNS3 (1:29)
Day 5
Chapter 8 - Network Layer part 3 - Host Routing - Static and Dynamic Routing Protocols (32:34)
Chapter 9 - ARP (19:59)
Chapter 9 - Neighbor Discovery (7:13)
Troubleshoot GNS lab (6:11)
Demo Remove Rip and Setup Static Routing (10:28)
Demo Remove Rip and Setup Static Routing using Exit Interface (8:44)
Chapter 10 - Basic Router Configuration (38:28)
Day 6
Net 44 - Chapter 11 Review and Exercises Part 1 (36:18)
Net 44 - Chapter 11 Review and Exercises Part 2 (46:07)
DAY 7
Chapter 11 VLSM Etc (73:46)
Chapter 12- IPV6 Addressing (27:27)
Chapter 13 - ICMP (8:42)
Day 8
VLSM Lab (11:28)
Day 9
Chapter 14 - Transport Layer (52:34)
Lab Practical 1
Lab vlsm
Day 10
Chapter 15 - Application Layer (21:45)
VLSM Practice Exam
Day 11
Lab Practical II
Day 12
Chapter 16 - Network Security (26:37)
Day 13
Chapter 17 - Build a Small Network (42:01)
CDP Demo (12:51)
Day 14
Connect GNS 3 to the Internet (2:25)
Demo - Configure GNS lab to connect to Internet Part 1 (10:16)
Demo Configure GNS Lab to Connect to Internet NAT part 2 (11:38)
VLSM Practice
VLSM
Day 15
VLSM FInal Practical
Connect GNS3 to Internet and configure OSPF and default route (16:41)
Connect VM to GNS3 (9:21)
Day 16
CDP Lab GNS3 (9:35)
Chapter 8 - Network Layer part 3 - Host Routing - Static and Dynamic Routing Protocols
Lesson content locked
If you're already enrolled,
you'll need to login
.
Enroll in Course to Unlock